With the growing number of battery electric vehicles coming into your workshops, you may want to create a designated work bay for these vehicles.
When removing batteries, you can be faced with difficult installation layouts that challenge the way you normally lift the vehicle. For these cases, we recommend a 2-post lift with wheel grippers. This allows you to lift the vehicle on the wheels instead of on the underbody frame, thus providing better access to the battery.
Not many lift makers offer wheel grippers as accessories. Please, check with your lift maker. For all those who anyhow plan to invest in a suitable new 2-post lift, we recommend the versatile OMCN 199-001RX or 199-002RY lift and the N199RX wheel grippers. If you already own an OMCN 2-post lift 199RX or 199WRX, you can buy the wheel grippers individually.
2-Post Lift 199-001RX - Technical Specifications
- Multiple joint arms to lift from compact cars to the long wheelbase truck.
- The universal solution for the whole of today’s fleet.
- 3 metres clearance between columns.
- Monobloc column structure for maximum sturdiness.
- Self-cooling motors with protection to avoid overheating.
- Management of levelling between the two carriages by electronic card with maintenance-free built-in fault autocheck.
- Carriage sliding on 6 steel wheels for maximum stability in all load conditions.
- Capacity: 5500kg
2-Post Lift 199-002RY - Technical Specifications
- Multiple joint arms to lift from compact cars to the long wheelbase truck.
- The universal solution for the whole of today’s fleet.
- 3 metres clearance between columns.
- Monobloc column structure for maximum sturdiness.
- Self-cooling motors with protection to avoid overheating.
- Management of levelling between the two carriages by electronic card with maintenance-free built-in fault autocheck.
- Carriage sliding on 6 steel wheels for maximum stability in all load conditions.
- Capacity: 6000kg
Wheel Grippers 199-003RX - Technical Specifications
- Special forks to lift the vehicle from under the wheels and allow free access to the underbody.
- Mandatory to remove the battery group from below.
- The set is compatible with Art. 199RX and 199WRX only andcan be mounted even on lifts already installed in a workshop.
- Easy to install: just take the pads off and put on the forks instead.
- Use it when you need it: no need to buy a new lift just for that use!
- The forks have rolls with bearings inside so that the wheel can roll freely.
- Capacity: 4000kg (1000kg per fork/wheel gripper)
To order this product:
Please, note that you cannot order this product from Bosch Automotive Service Solutions. For this product, Bosch accepts no liability for defects in material, workmanship or title, nor for the completeness or accuracy of the Product description.
Please, reach out to the manufacturer directly by sending an e-mail with the request for a quotation: web@omcn.it
Please refer to these product codes:
- 199-001RX - 2-post lift 5500kg
- 199-002XY - 2-post lift 6000kg
- 199-003RX - wheel grippers